These little table toppers are quick and simple to make. I hope you will enjoy the following tutorial. There are several on the web and you can purchase patterns if you like.
* * *
To start with you will need:
1 - 12.5 inch square of background fabric.
2 - 5 inch squares of background fabric.
1 - 20 inch square of batting
1 - 20 inch square of backing fabric
1 - 12 inch square of pellon 805 fusible
Assorted scraps of holiday fabrics for leaves and ornaments.
2 - 2.5 inch strips cut width of fabric (40-44 inches) for your
binding.
* * *
To make the ornaments, I cut strips of fabric random widths and stitch them together. I used a cup to trace 4 circles on the Pellon. I rough cut them out and placed them as desired on the strip set. Press the Pellon patterns onto the backside of your strip set and then cut out carefully with sharp scissors.
Using random bits of scrap fabric for the leaves, draw your leaves and berries onto the Pellon and again, press them onto the wrong side of your fabric. Carefully cut out your pieces with sharp scissors.
Take your 12.5 inch square of fabric and fold in half, press. Do this again the opposite way and again on both diagonals. See below.
This will create lines to help you place your pattern pieces in a symetrical fashion.
Now, lay out your pieces as desired and press into place.
Take your 5 inch squares and cut them both on the diagonal as shown below.
Fold your triangles in half and finger crease on the long side, do the same for your block, fold it in half and finger crease. This will help you line up your pieces uniformly. I have placed a purple mark to show you below, but your finger crease will be evident and it is not essential that you mark your fabric.
Pin your side pieces to your blocks, matching your finger creases. I like to place three pins, one in the middle and one at each end. Be careful not to stretch these triangles, they are cut on the bias.
When you have them all stitched on, press to the outside.
Now for some decorative top stitching. I like to place a 12 inch square of Pellon Stitch-N-Tear Lite beneath my fabric for stability.
Pin the Pellon Stitch-N-Tear into place so that it does not shift while you are stitching.
Stitch your pieces into place with your desired stitch, straight, satin or perhaps blanket stitch or another decorative stitch of your choosing. This is the time to satin stitch your ornament tops. I just stitch back and forth until I have the desired shape and then stitch a little circle around the top with straight stitching a couple times. If you are not comfortable free handing these, you can draw them on with a disappearing quilt marking pen to make it easier.
Place your backing down, wrong side up, then place your batting and your table topper. You should have plenty of batting and backing on all sides. Iron and then pin into place. Quilt as desired. Carefully trim your block and bind the edges. There is a great binding tutorial that I will link here: http://thecraftyquilter.com/2013/06/how-to-bind-an-inverted-corner/
Wasn't that fun! I am making lots of these right now.
Thanks for stopping by, I hope you and your family have a very Merry Christmas!
